You can drag the end of the measure selection to change the measure’s length. The Beatmapper Wizard uses a single measure length for the entire song. Drag the Measure slider to scroll through the song, and click the Play button to verify that the detected measure length is accurate throughout the song. The waveform is displayed with markers at the end of the measure. Select the Metronome check box if you want to play a click track at the detected tempo. Otherwise, drag the ends of the loop region to the appropriate locations and click Next.Ĭlick the Halve Selection or Double Selection buttons or drag the ends of the loop region to adjust the measure length.

If the region is positioned correctly, click Next. The Beatmapper Wizard will draw the file’s waveform and place a region to indicate the length of the first measure.Ĭlick the Play button to verify the measure’s length. Otherwise, drag the marker to the appropriate location and click Next.Ĭlick the Reset button to return the downbeat marker to its original position. If the marker is positioned on a downbeat, click Next. The Beatmapper Wizard will draw the file’s waveform and place a marker to locate the first beat of the first measure.Ĭlick the Play button to verify the marker’s position.

Open the Clip Properties window for a Beatmapped track, switch to the Stretch tab, and click the Beatmapper Wizard button. The file will maintain its original length regardless of the project tempo. Select the No radio button and click Finish if you want to add the file as a one-shot. The file will be able to stretch/compress with the project’s tempo. Select the Yes radio button and click Next to detect measures and downbeats. If tempo information is not detected in the file, the Beatmapper Wizard starts. Perform either of the following actions to start the Beatmapper Wizard:Īdd a long file to your project. Support for multitempo clips is available for clips that are recorded or rendered in ACID or by adding Beatmap markers on the Clip Properties dialog.

Use the Open files as loops if between (seconds) setting on the Audio tab of the Preferences dialog to determine the file length. The Beatmapper Wizard is started by default for files longer than 30 seconds. When a long file is added to a project, the Beatmapper Wizard starts to allow you to add tempo information to the file.

Acid music studio 10 finding bpm